HFSS計算問題
我的程序檢查過，沒有問題，但在計算的過程中，下面卻顯示有好多錯誤，我看了一會，沒看懂，這樣計算出來的數據是否正確？哪位大蝦幫忙解決一下，如果有問題，請給出解決方法，錯誤提示如下
HFSSDesign1
[info] Parametric Analysis on ParametricSetup1 has been started. (5:22 PM 三月 20, 2010)
[info] A variation (h='8.25mm' k='8.3mm' l='3.9mm' l_diapole='4mm' length='0mm' ll='14.85mm' n='3.6mm' o='4.1mm' p='3.3mm' pp='3.6mm' qq='14.85mm' u='8.325mm') has been requested (5:22 PM 三月 20, 2010)
[error] Acis error: "Failed to make rectangle.. Acis Error 44072 - cannot make wire with duplicate vertices " (5:22 PM 三月 20, 2010)
[error] Body could not be created for part Rectangle1 because of invalid parameters of this part or some of its parent part/coordinate system. (5:22 PM 三月 20, 2010)
[error] Acis error: "Failed to make rectangle.. Acis Error 44072 - cannot make wire with duplicate vertices " (5:22 PM 三月 20, 2010)
[error] Body could not be created for part Rectangle2 because of invalid parameters of this part or some of its parent part/coordinate system. (5:22 PM 三月 20, 2010)
[error] Acis error: "api_check_entity failed for part: Rectangle1" (5:22 PM 三月 20, 2010)
[error] Acis error: "api_check_entity failed for part: Rectangle2" (5:22 PM 三月 20, 2010)
[error] Null body found for part Rectangle1. (5:22 PM 三月 20, 2010)
[error] Null body found for part Rectangle2. (5:22 PM 三月 20, 2010)
[warning] Failed to extract solution for 'li: Freq(Single value at 10GHz)'. (5:22 PM 三月 20, 2010)
[info] A variation (h='8.25mm' k='8.3mm' l='3.9mm' l_diapole='4mm' length='0.4mm' ll='14.85mm' n='3.6mm' o='4.1mm' p='3.3mm' pp='3.6mm' qq='14.85mm' u='8.325mm') has been requested (5:22 PM 三月 20, 2010)
看英文噻，你變參數的時候有的圖形大小改變后，你的有些操作就有問題了，比如Boolean操作什么的切得東西啊什么的
這種情況如何解決，算出的數據正確嗎
